Follett C/E25HT400A/W Bedienungsanleitung PDF herunterladen (Seite 21)

Action

Check LEDs on control

board.

Place cup under drop

zone.

LED Status

PWR CLN ICE/WTR

OFF OFF OFF

ON ON OFF

ON OFF OFF

ON OFF ON

Solution

Check circuit breakers and power switch; restore

power or replace defective switch.

Depress clean switch located under left side of front

cover to return board to normal operation.

Troubleshoot appropriate lens/sensor and replace if

required (see Lens/Sensor Troubleshooting below).

Verify power on appropriate output terminal (WTR or

WM) on control board and replace board if required;

if board tests okay, troubleshoot appropriate

dispenser component.

Problem: Does not dispense ice or water

Action

Check LEDs on control

board.

LED Status

PWR CLN ICE/WTR

ON OFF ON

ON OFF OFF

Solution

Troubleshoot appropriate lens/sensor and replace if

required (see Lens/sensor troubleshooting below).

If there is power on any output terminal (WTR or

WM) on control board, replace board.

Remove lens protective cover; adjust funnel so water

doesn’t drip down lens or behind splash panel.

Problem: Dispenses ice or water continuously

Board guide

LEDs, when illuminated, indicate the

following:

PWR (board power)

CLN (cleaning, no dispensing cycle)

ICE (ice dispensing activated)

WTR (water dispensing activated)

Terminals:

L1 (incoming power, hot)

L2 (neutral terminals)

WTR (power terminal for water solenoid)

SOL (power terminal for dispense gate solenoid) not used

WM (power terminal for wheel motor)

CLN (terminals for clean cycle switch)

Troubleshooting SensorSAFE board and sensors

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 31 32

Kommentare zu diesen Handbüchern

Keine Kommentare

Follett C/E25HT400A/W Bedienungsanleitung Seite 21

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Eiswürfelmacher Follett C/E25HT400A/W